From Wikipedia, the free encyclopedia

This article does not cite any references or sources. (September 2007) Please help improve this article by adding citations to reliable sources. Unverifiable material may be challenged and removed.

Audio feedback (also known as the Larsen effect after the Danish scientist, Søren Larsen, who first discovered its principles) is a special kind of feedback which occurs when a sound loop exists between an audio input (for example, a microphone or guitar pickup) and an audio output (for example, a loudspeaker). In this example, a signal received by the microphone is amplified and passed out of the loudspeaker. The sound from the loudspeaker can then be received by the microphone again, amplified further, and then passed out through the loudspeaker again. This is a good example of positive feedback. The frequency of the resulting sound is determined by resonant frequencies in the microphone, amplifier, and loudspeaker, the acoustics of the room, the directional pick-up and emission patterns of the microphone and loudspeaker, and the distance between them.

More specifically, the conditions for feedback follow the Barkhausen criterion, namely that an oscillation occurs in a feedback loop whose delay is an integer multiple of 360 degrees and the gain is equal to or greater than 1 (both at the given feedback frequency). If the gain is greater than 1, then the system can start to oscillate out of noise, that is to say: sound without anyone actually playing.

Most audio feedback results in a high-pitched squealing noise familiar to those who have listened to bands at house parties, and other locations where the sound setup is less than ideal — this usually occurs when live microphones are placed in the general direction of the output speakers. Professional setups circumvent feedback by placing the main speakers a far distance from the band or artist, and then having several smaller speakers known as monitors pointing back at each band member, but in the opposite direction of the microphones.

Feedback can be reduced manually by "ringing out" a microphone. The sound engineer can increase the level of a microphone or guitar pickup until feedback occurs. The engineer can then turn down frequency on a band equalizer preventing feedback at that pitch but allowing maximum volume. Professional sound engineers can "ring out" microphones and pick-ups by ear but most use a graphic equalizer connected to a microphone to show the ringing frequency.

To avoid feedback, automatic anti-feedback devices can be used. (In the marketplace these go by the name "feedback destroyer" or "feedback eliminator".) Some of these work by shifting the frequency slightly, resulting in a "chirp"-sound instead of a howling sound due to the upshifting the frequency of the feedback. Other devices use sharp notch-filters to filter out offending frequencies. Adaptive filters can be used to tune these notch filters.

This section does not cite any references or sources. Please improve this section by adding citations to reliable sources. Unverifiable material may be challenged and removed. (November 2007)

While audio feedback is usually undesirable, it has entered into musical history as a desired effect beginning in the early 1960s. Although it is now well associated with the history of rock music where electric guitar players such as Pete Townshend and Jimi Hendrix have used it extensively, it was the contemporary American composer Robert Ashley who first used feedback as sound material in his infamous work The Wolfman (1964). The Beatles' inclusion of feedback, the same year, in the opening of "I Feel Fine" is sparse compared to the twenty minutes of vocal feedback in Ashley's composition. However, the Beatles' single, released in the UK in November 26, 1964, is widely considered the first example of feedback included in a commercial recording.^{[citation needed]} It was used extensively after 1965 by The Monks and The Velvet Underground. Used in this fashion, the artist has some control over the feedback's frequency and amplitude as the guitar strings (or other stringed instrument) form a filter within the feedback path and the artist can easily and rapidly "tune" this filter, producing wide ranging effects. Artists can even manipulate feedback by shaking their instruments (in the style of Pete Townshend) in front of the amplifier, creating a throbbing noise.

The principle of feedback is used in many guitar sustainer, be it in the form of ebow or sustain pickups or sonic transducer that's mounted on the head of guitar.

Also note that desirable feedback can be created by an effects unit by using a simple delay of about 50 ms feed back into the mixing console. This can be controlled by using the fader to determine a volume level.

• Optical feedback
• Circuit bending

Audio Feedback