Sources
Help build the largest human-edited directory on the web.
Submit a site - Become an editor
Wikipedia. Licensed under the GNU Free Documentation License.
Are you an expert in this subject? Join the discussion and share your knowledge at Wikipedia.org.
Slew rate
From Wikipedia, the free encyclopedia
In electronics, the slew rate is a nonlinear effect in amplifiers. It represents the maximum rate of change of signal at the amplifier output.
In mechanics the slew rate is given in dimensions 1/T and is associated with the change in position over time of an object which orbits around the observer.
The slew-rate of an op-amp is defined as the maximum rate of change of the output voltage for all possible input signals.
where vout(t) is the output produced by the amplifier as a function of time t.
Slew rate is typically expressed in units of V/µs.
The slew rate can be measured using a function generator(usually square wave) and oscilloscope.
There are slight differences between different op-amp designs in how the slewing phenomenon occurs. However, the general principles are the same as in this illustration.
The input stage of an op-amp is a differential amplifier with a transconductance characteristic. This means the input stage takes a differential input voltage and produces an output current into the second stage. The transconductance is typically very high — this is where the large gain of the op-amp arises. This also means that a fairly small input voltage can cause the input stage to saturate. In saturation, the stage produces a nearly constant output current.
The second stage of an op amp is, amongst other things, where frequency compensation is accomplished. The low pass characteristic of this stage approximates an integrator. A constant current input will therefore produce a linearly increasing output. If the second stage has a compensation capacitance C and gain A2, then slew rate in this example can be expressed as:
where Isat is the output current of the first stage in saturation.